Check Condition of Oil Engine oil is a very important role to lubricate machine components, such as pistons, piston and piston rings, crankshaft and Noken and valves. Therefore, if the presence of lubricating oil is blackish color its lubricating power is reduced, then it should be replaced. Oil change periodically and use in accordance with manufacturer recommendations.
Check Condition of Battery Do not let water pass Accu maximum and minimum limits that you may cause accelerated damage to the cell-cell batteries. In addition, if the battery or the battery is already weakened quickly replaced, because if imposed in addition to both positive and negative poles will issue corrosion (white powder), the corrosion will spread to the cables that connect the main electrical current to the channel lights, dynamo, or other parts. Therefore, in case it is, electrical current delivered battery or batteries are not perfect and can cause damage to the components of the armature, a contact switch engine and lights. One thing to note if the batteries are weak or can not afford the starter and the starter, or electric shock should be replaced.
Check the chain and gear Do not let the chain is too loose or too tight. Too loose can make the chain dislodged from his gear, while too tight could result in breaking the chain. Also check the condition of gear, if it is sharp because, if not immediately replace the chain can suddenly drop out.
Check the coil and spark plug cables Note the presence of coil wire that connects the electrical current to the spark plugs. If you are old enough and have seen there are cracks and hardening on the cable, then it should be replaced. Also note the presence of spark plugs for spark plugs is vital for the smooth operation of a vehicle engine.
Note Gasoline Hose Another component to note the fuel hose to the carburetor. Do not let the condition of the fuel line hardens or cracks occur, because the inside of the hose could have been so inelastic that resulted from the powder hose dirt washed into the carburetor. Which will eventually happen blockage of the gasoline supply tank to the carburetor so that interrupt the ignition system
Heat Machine Oldest 2 Minutes Heat the engine before the motor is started, no need for long enough 1-2 minutes. This is so that the circulation of the oil can lubricate all moving parts in the engine. Do not heat too long because it will make the exhaust pipe yellowed otherwise it will just be wasting gasoline.
Check Tire Pressure Wind Do not be too hard and also not less because the motor can result in tire damage.
If these steps are done correctly, the motor will always be your pet in a fit condition. (Source)
No comments:
Post a Comment